Coyote help needed
 

Hi guys, I just noticed my fan isn’t turning on ( 2011 coyote crate and frpp controls pack ). The fan is aftermarket with a fuse ( fuse is good ) I ran power to the fan and it works. I checked the 40 amp fuse in the controls pack and it’s good and there is power at the terminal. Next I went to check the relay which leads to one of my 2 problems
The relay shattered going to remove it. I went to my local ford dealership but they can’t find a replacement part number, they called ford performance and they were told they think it’s not replaceable? And I will probably damage the circuit board trying to remove it?
So the 2 problems are I don’t know it I should even be trying to remove what remains ( I really think it is at minimum stuck not at all loose ) and even if I get it out I can’t find replacement
And 2, my fan is still not diagnosed
Ideas? Thanks

Possibly a water temp sensor issue or connection issue where it's not sending the signal to turn the fans on?

This thread is pretty much the bible for Coyote aftermarket when I was building my Cobra with a Gen 2 Coyote. Paul is really good about getting on the phone and helping people diagnose Coyote issues.

https://thefactoryfiveforum.com/show...iversary-Build

Thanks, I’ll try get in touch with him
The black relay looking item under the purple one is what I have broken. I just looked at it again and think it is non replaceable. Pretty sure this is going to get expensive damn it.

Any decent electronics tech could desolder and replace that relay. The part number is on it. Google it.

Don