Chris's 66 Chevelle upgrade
 

A little past history on this car....... I bought it back in 2005 and did the Body and Paint, suspension, brakes, and added a 406 small block and 700R4 trans....... Great car... Took it on it's first of many Power Tour Long Haul's in 2006..... My son Chris got the car in 2010 and continued the tradition of driving on the Road Tours

https://hosting.photobucket.com/albu...s/DSC01817.jpg

https://hosting.photobucket.com/albu...s/DSC01812.jpg


So...... Fast forward to 2020 and we did the 1st Barrett-Jackson Road Tour and I was driving my LSA powered 66 Chevelle (just turned 34,000 trouble free miles) and Chris had the 406 powered car........ After driving and comparing the differences I finally convinced him to swap out the Old School to Modern Technology ......and so it starts..... LOL...... Bought a LS 3 connect and cruise 4L70E set-up, Ricks Tank with a Vaporworx fuel pressure set-up, adding a HydraBoost, Dakota Digital Dash and controllers, also a Holley mid mount front drive assy to clean things up, and a Hooker LS mounting kit.......

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds


https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

Here we go !!!!

That’s awesome - look forward to following along as you upgrade. You’re making some really nice improvements which will make the car so much more reliable and easier to drive... that said, looks like the 406 did pretty well for itself, too, with all the tours you and your son have taken with it.


Sent from my iPhone using Tapatalk

Wow 34k miles and that many PT long hauls is really cool to see, looking forward to how this one comes along.

Looking forward to following the build.

Subscribed.

Looking forward to this build.


Sent from my iPhone using Tapatalk

Got the Holley 302-3 oil pan installed...... also the Holley mid mount front drive assy.....the Holley / Hooker forward bias engine mounts arrived and were installed....

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

Also the Rick's Tank and Carls Vaporworx PWM fuel pressure control system are here.......

https://hosting.photobucket.com/imag...080&fit=bounds

Included in the Holley / Hooker install kit is the transmission crossmember...... Boy.....30 minutes and it was done....what a treat to get something that actually fits as it should..... there are two mounting plates that bolt right into the existing frame holes ..... bolt it in and drill two hole thru the side frame, bolt it in and you are done......And the side mounts have all the various mounting holes designed in to accommodate all transmission variations ......

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

https://hosting.photobucket.com/imag...080&fit=bounds

Nice setup. Subscribed.

Very cool! Looking forward to see the progress!