![]() |
Fuel tank electrical pass through
Looking for a pass through that can handle 20 amps.
Similar in design to the below link. This one uses MP150 terminals which are rated to 14A. Needs to a 90 deg due to tank to trunk floor clearance. https://www.racetronix.biz/p/fs-bulk...y-4-way/bca-4w |
Have you checked out waytek yet?
|
Didn't see anything there for the cause. Component needs to be tight 90 deg out of the sending unit for clearance. Found a few straight options for single leads. Could make that work, however, trying to keep it clean looking
|
Deutsch Bulkhead Connector
4 Attachment(s)
This is what we used on my Firebird...
|
Pressure sensor or Alcohol content sensor?
|
Holley Terminator EFI
Quote:
|
All times are GMT -5. The time now is 01:59 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright Lateral-g.net