69 Camaro steering column to dash clearance
 

Hi guys,

So dry assembling my car, 69 Camaro stock dash carrier and stock tilt column, the column is hitting the dash carrier before I can barely get the nuts started. I see they sell a shim below, but the assembly manual does not call for it on the 69. Does anyone know do I use this shim? If so, just one side or both sides and which way does it go in (handle pointed to front of car)?

This is what I get for starting with a basket case!

Thanks in advance for any help!! Ron

https://www-rickscamaros.com.imgeng....3-384823-1.jpg

Following this as well. I used some washers below to space mine down 1/8th inch to clear my racepack which is surface mounted. This shim looks like a much more appropriate method.

Mine came with a shim and a nylon shim/gasket I just put them back the way they came out. Shoved the shim in deeper to get proper clearance for the dash panel..

Update: I noticed the instrument cluster was a little low (bottom not right up against the inner structure). So I had to clearance the upper mounting holes to allow the entire cluster to be raised approx. 1/8 inch. The column still made heavy contact with the cluster but I was able to use regular fender shims to drop it 1/8 inch and still have the nuts threaded all the way on the support rods.