F/S 383 Stroker
 

Hey guys,

FS: 383 Stroker

Scat 9000 Crank
GMPP Rods 5.7"
KB Hyp 10:1 Pistons
Clevite Bearings
Stock 5qt pan
stock 400 Balancer
SFI flexplate

Comp Cams 292X
Hyd Flat Tappet
Adv: 292/292
@0.50 244/244
Lift .511/.511 with 1.5 roller rockers

Heads: http://www.canfieldheads.com/sbc.html
ALUM. Canfield 220cc Race heads
Stainless 2.06/1.65 valves
10 degree keepers
Comp Springs
Paid $2200

Edelbrock Performer RPM Air Gap Intake
Edelbrock Valve Covers
Electric Water Pump

I ran this combo with HEI and a 650 DP with a turbo 350 Trans and 3.73 gears.
I ran 12.14 in a fully dressed Regal. I have video to prove it.

I love this engine, wish I could use it but I am going turbo. She runs on pump gas and always has. Likes 34 degrees of total timing. Has a great street presence, lopey but still good enough vacuum for vac brakes. On an chassis dyno I made 375hp and 440ft/lbs in 90 degree weather and 180degree water temp. Only about 1000-1500 miles on her. Has only been to the strip twice. Mainly just went to cruise-in's. If you have any questions please feel free to PM me.
Asking $4000 intake to pan. I have a carb also.

Jeff

Comments, Questions?

Jeff

I have a set of the same Canfields that have been CNC'ed and they make awsome power. Great set of heads!!!


Good luck with the sale.


-Dave

I love them and thanks

ok guys, I need to sell this engine.

$3500 OBO

Jeff