Looking for LS1 / T56
 

I'm lookinf for a 2001-2002 F-car LS1 and T56 power train for my next project. Complete drop out all accy.

Any leads or contacts would be appreciated.

Stielow

Have you checked at eBay?

I usually check there for a setup like that but at the moment I only found some from a '98.

Charley said that you were going over to Nurberg ring later this year. How are those plans going? I might do it myself, just one days drive from where I am, maybe we could see each other there?


Jan

Leads
 

http://www.ls1tech.com/forums/forumdisplay.php?f=45

This forum has a very active "For Sale" section. It would also make sense to post this in the "Parts Wanted" section there as the site has a huge membership--more eyeballs, more leads.

Also, I missed your message this morning. Good luck.

I posted a wanted ad on LS1 Tech and had quite a few people with setups for sale, also try Ebay, e-mail some sellers if they have any other stock. I did find a few setups that way, but was like you looking for a 2001+, the Ebay sellers will be more expensive than a seller on LS1 tech. And watch out for scammers, I had guys sending me pics they pulled off ebay so I would send them money, so be weary. If the deal is too good to be true, then it is!

I did get mine through a seller on LS1 Tech, found the best deal there. 2002 F-body LS1 with T56, all accecories, wiring harness/PCM, rad/fans, exhaust etc for $3800 + shipping.

Mark-
Try John Wilson, formerly of Flowmaster Mufflers. He does F/Y body salvage and can usually get or has on hand most items you'd want. Tell him I sent ya.

[email protected]

Tyler

John Mr Wilson
 

Hey Tyler, is he in California? still?

Vince

These guys may be worth a call.

http://www.gmsports.com/

You might want to try:

Shaun Carter
SMC Performance, Inc
248.276.0483

[email protected]



I have always been able to get things from him as he deals in a ton of LS1 stuff..


Don't know if this will help you or not but I have an LS1 block, crank and 15-16 stock rods/pistons sitting on my shelf that I would like to get rid of. It will need a rebuild (Gaskets bearings ect).. PM me if your interested in it.

This is everything I have to get rid of:
98 Block
Crank
98 Heads (Complete)
Oil pump
Valve Covers
Fuel Rails
28lb Injectors
LS1 Intake
LS1 Valley Cover
Stock Manifolds
Throttle Body
Crank Pulley
Wires



Shaun Liddy

Just wondering what new project your doing now?
any hints?

You might want to give these guys a shot. He had several when I was considering the same swap.

Hope this helps! :willy:

Billy Graham Camaro Salvage

Rob