NEW ported DART PRO 1 heads
 

NEW ported DART PRO 1 heads

New hand ported aluminum Dart Pro 1 heads flowing over 300cfm at .700" lift. Care was taken to achieve the best CFM vs velocity possible. Swain coated chambers, Manely severe duty valves (I believe undercut as well), cryo treated springs, 1.7 Comp magnum rockers, stud girdles, custom painted cast Chevrolet valve covers with welding done ready for vacuum pump. Chambers are 64cc, runners are about 225cc (started as 195), and they are standard 23 degree heads.

These have never been used. They were bolted to a motor and then unbolted. They look and are like new in every way. I received these in a trade and have since sold the block I was going to use to build this motor.

They're in South Jersey, but can be shipped no problem.They're yours for $2000. There is around $4000 in them. I'll trade for newer dirtbikes, ATVs, jetskis...

John
[email protected]
856 905 1908 cell

http://i44.photobucket.com/albums/f1.../4-6-07001.jpg

that is cheap. Some one better jump on them.

They really should because I'm about to by a 400 short block and build a second motor with these!

I'm ordering a short block on Monday for these heads. Act fast before I do something stupid. :D

If I didn;t already have my 18 degree motor....you would no longer own those. Have you tried www.racingjunk.com. I have had good luck there with parts like your heads

Yup, they're there. I've had some offers for KTM dirtbikes in trade, but I think these will be pretty sweet on a Dart billet cap 400 with a Callies rotating assembly and belt drive (and maybe a little funny gas via fogger) :thumbsup:

Sold!

Still For Sale!!!

Somebody really needs to step up for a good deal!

Sold!