Stance... what do you think?
 

http://memimage.cardomain.net/member...2524306_33.jpg

http://memimage.cardomain.net/member...2524306_32.jpg

http://memimage.cardomain.net/member...2524306_31.jpg

http://memimage.cardomain.net/member...2524306_30.jpg

http://memimage.cardomain.net/member...2524306_29.jpg

Why? That stance is perfect!!!:thumbsup:

John

Its frakkin schweet.

I would go a hair lower in the front, from the first pic it looks like the distance from the top of the fender gap to the top of the wheel is a little bigger in the front than the back giving a wheelie look, but it could just be cause it is a small pic.

The rear is money but the front could be just a tick lower, But it looks sweet at that height now, but just a tick in front would awesome, just my 2 cents.

Rodger

I agree.

front a bit lower

Thanks guys. I don't know if I can go any lower in the front. I have two inch lowering springs installed now and we have cut part of a coil to get it where it is now. Any suggestions??

How about bringing it up just a slight bit in the back to even the gaps? The height in front looks perfect, so if you make the rear match, I think you've got it.

Well, how could I go about raising the rear? I installed the 3" drop leafs that I got with my DSE mini tub kit. Is there anyway to raise it just enough without replacing the rear leafs again? I know you can install lowering blocks to lower the rear but how would you raise it?