It would get covered up by the oil lines in the current location - and for me the tack welds detract my eye from looking at the design and craftsmanship of the part. I'd move the logo to a spot where I knew it wouldn't get covered up (lines, studs, bolts - something like the spot right next to the 90 degree fitting bends) - make it proportional in size to the things around it - then using a paint mask, logo into that position and either acid etch, glass bead, or spray some shade of black/grey color - and clear over the whole deal. Or you could eliminate this sides logo while leaving it on the other side in the current location and etch it there. (something like the effect of the laser etching on the back of watches)
I really like the entire line of products and not trying to be disrepectfull. Just throwing out ideas while you're in development of what I might want.
Good Luck !
Jim
|