Quote:
|
Originally Posted by ItDoRun
The search is on! What mods are necessary for installation in a 1st gen Camaro? Specifically the trans tunnel. Also what crossmember will I need. Thanks for all the help.
Chris
|
They clear the stock tunnel, but are tight. Some people have to massage the area where the cooler lines exit the trans, but they cleared on mine.
I have not found a bolt-in crossmember yet, but it was a couple years ago that I set up mine. I do know at the time the BTO had one that they claimed fit, but it was not even close, off by 8" or so. I made my own crossmember from a universal kit bought from Chassisworks.
You also have to have a controller to run the trans, so allow for that in the budget (about $500-$600).
Jody