[Steve Chryssos]

Thanks guys. Looks awesome.
I found some material that might work well. Ordering some up. 71% open area--which is acceptable, 40 thou thick, hexagonal perforation--not mesh, so it won't sag like mesh. If it works, we'll sell it as an option. Good for low to medium power fuel injected applications with front inlets such as LS motors. We will continue to recommend against its use for carbureted and big power applications. But it's up to you to decide. It would suck if a silly trim plate promoted overheating at idle or caused you to recalibrate your carburetor.

Just looking out for your guys. It's a amazing how much thought needs to go into a little screen--unless you're just trying to keep bugs out of the house.