Quote:
|
Originally Posted by TOM NELSON
340 to the ground is probally about 460 hp.I would check a couple of things one do you have 9 pounds in the manifold at your peak rpm serpentines will slip and if it does the car will feel soft as hell.Two with 9 psi even on a 8.5 to 1 350 with the hot cam you should be making at the very least 580 hp crank and you would definately feel that.I'm not sure if you said your transmission but if it's a auto are you sure it's not sliping,just a thought.Run a compression check on all cylinders see if there within 10 percent of each other and at least 110 pounds cranking.If you have that than i doubt it's in the motor.I've had problems with the procharger units I actually have not used your blower before though but in the past there smaller blowers just did not cut it.I had a 383 with a blower i believe was similar to yours lay down 310 to the ground.We changed pulleys you name it.Not big improvements .Switched to a ysi vortech it picked up 400 hp.and made 710 to the ground and the cam was much smaller than your hot cam.I had good luck with there bigger units like the f2's but even there above 10 psi they really start making heat fast.Ignition Timing can be a huge deal on a 8.5 to 1 motor I've seen 100hp from 25 to 35 degrees the low compression engines like timing at 9 psi and only 6000 rpm But beware carbs timing and boost is a scary deal.If it was mine and i felt good about the tuner i would not shy away from 35degrees total timing at 9si and 6000 rpm this can literally transform the engine.Again beware creap up on it.I would for ****s put some 110 in it and put total at 35 dgrees and see what happens given afr's are in the high 11's low 12's.Hope you fiqure it out
|
Tom, with his BTM he's only got about 15 degrees of timing at WOT and full boost. I think this is a huge power killer, and gave the dyno guy a couple other things to try. Bottom line, he's got to get more timing in the thing, if that takes water injection or whatever.
Jody