[oldzzy]

Well i finally am able to do some more work on the 70 Cutlass again. I have some rust on the drivers side floor pan to fix up. I am drilling out the spot welds on the center floor brace so that i can remove it. The worst part of the floor is above the center brace. I have finally removed everything from the interior of the car so i have less weight when i flip the car on it's side. I bought a full length drivers side pan and a new center brace but i think i might be able to reuse the original center brace. The new center brace has the seatbelt holes in a different spot than my original. Now since my car was originally a bench seat car i am not sure if the bucket seat seatbelt location is different or the same. The original holes are more forward than the repo piece. I am going to bucket seats.