OK, while a digital photograph is not as good as scanning \ digitizing the dyno sheet, this will have to do until Monday or Tuesday. Here is a link to a few digital pics of the dyno sheets.
A few things to point out:
1) The max torque was realized at 4,800 RPM's and the max HP at 5,800 RPM's
2) This is a chassis dyno (look at the lower right corner) made in New Zealand so to the dyno maker the rear (or any drive wheel) is the fly wheel. These #'s are at the rear wheels.
3) The red line was our base run and the green line is the final run.
4) Once you land on the foto-time page you should click on the thumb nail to make it 5X8 and then click on the 5X8 image to make it full screen so you can read the sheet.
http://www.fototime.com/inv/333D04902474792
Again, big thanks to rebird and Goodies!
Chris