Pypes exhaust
After searching in the exhaust section I had a question about the Pypes mandrel bent (or any other similar mandrel bent) exhaust system. I want to install the system myself at home on my new 68 Camaro RS (small block). I have a lift but no welder (or welding skills). Can this (or any other similar system) be installed properly without welding? There is no problem if I have to cut off some sections of pipe to adjust for a proper fit, but will it seal/fit properly just using whatever type of clamps (band or other) and hangers that come with the kit? I was thinking of the 2.5" Pypes system w/Borla mufflers.
Any help in this area would be appreciated.
Thanks,
Marty
|