Quote:
|
I REALLY do not want to hardwire my EFI harness through a grommet.
|
Jim, I will agree with you on the no grommet thing, but for the price of the big mill-spec connectors and the rediculous amount of studying to even figure out what you need, I was looking around on Summit and found somthing called "Seals-It". It is a grommet, and it is a very good grommet. I ordered a one for a fuel line to go out of the trunk and under the car, one for the battery cable to come out of the trunk and under the car, used another for the main battery supply to the electrical box inside the car from the starter motor, then used the last one on the big harness from the LS1 engine to the computer inside the car.
The one for the harness is a two piece design. You can get it in various sizes, but the one I needed, they didn't have, so I simply ordered a blank one with no hole.....I made my own to fit 76 wires and the insulation thru it. I made the custom block off plate on it as well. It looks good and I think it's going to work pretty well too.
Here is a pic........
http://i198.photobucket.com/albums/a...4/100_2766.jpg
http://i198.photobucket.com/albums/a...4/100_2765.jpg
http://i198.photobucket.com/albums/a...4/100_2768.jpg
Hope this helps out someone,
Joe