Got it all worked out. Called the guys at cc5 to check if it was possible it could be the new bell housing. They didn't think so, but said there is a first for everything. They offered to ship a new one. At this point I went down and got some off set dowels. After spending a lot of time trying to get the old dowels out I found the problem. The guys down in mexico put my dowels in at an angle(darn target motor). You could see in the holes where it had a lip from the dowels being pushed in there wrong. I got the dremal out smoothed out the lip and put in my .007" off set dowels now my runout is down to .002" not to bad.
