Well, I drilled the hole in the bottom radiator support so that the radiator could sit in its proper place. Im thinking of using some rubber washers so that the radiator will sit on a cushioned surface. I may need to cut a little off each prong to clear my front valance. I Also still need to cut a little notch out for the drain tap, but after that I can weld in the lower support. I put the hood on to see if the filler neck still cleared the hood, and it does, which means all my test fitting paided off.
Last edited by Dodgenut64; 01-13-2008 at 05:42 AM.
|