[Garage Dog 65]

I was amazed again at how much sand was in the frame.

This view shows how the perimeter frame rails will tuck up and under the door recess - turn the corner at the rear tire - and cross over to connect up with the trans hoop. I cut out the jack spur and the rocker supports. The rocker supports will go back in later and be removable. I'm making the frame removable from the body - so there will be body mounts at the front and rear of the door through the door sill. There is a sill plate that will cover it up so it will look stock.

Tiger, I thought about doing the #4 design - and leave an area in the middle where I could drop in a Porsche shield. Thanks for the comment and also thanks for the info on your Porsche brake calipers, much appreciated !

Jim