Hi All,
7-25 update part two…
Finally, here are some photos of the car as she sits waiting for pick up. Upon return, we should be able to complete the front end and get this baby ready for paint.
Here is a shot of the rear end with the lower valance in place. Note that the bottom edge of the valance runs parallel to both the gas tank and the ground. Also, in order for us to get the flare contures correct, we had to shift the bottom of the quarters out about and inch or so. In order to get the rear valance to fit up properly we had to segment the panel (add two pie shaped filler strips). If I hadn’t said anything, you probably would not have noticed.
Here we have two shots of the finished body (at least from the cowl to the rear bumper).
And finally, here are some photos of the interior. The door panels are two that we have used for fit up porposes only. Note how the 03 dash meshes up just right with the 65 door panels. We are going to eliminate the vertical ribs in the center of the door panels and fill that area with a simple padded insert. Maybe we can come up with some embroidery with a SN65 emblem. We are going to use the standard door pulls instead of the pony items. I like the way the standard pulls line up with the angle of the 03 dash.
That’s all for now.
Catch ya’ll l8r.
Bob
Come see this WIP at
Julian's Collision Center
http://www.julianscollisioncenter.com/