View Single Post
  #4  
Old 03-03-2008, 07:33 PM
ironworks's Avatar
ironworks ironworks is offline
Senior Member
 
Join Date: Oct 2005
Location: Bakersfield, Ca
Posts: 5,155
Thanks: 4
Thanked 30 Times in 19 Posts
Default

You could do the obvious and run the wires and such through the frame. But why not hard line the air and fuel and route the wiring so clean it look great. We make special line clamps for our tube frame to hold brake and fuel lines, and incorporate them in the design. I'm gonna buy the high end hose crimper from XRP just to do the air and fuel lines in the green kevlar hose. That stuff is bitchin. There are some really bitchin place to get cool wiring and fittings from.

On the bed of the C6-57 we made the side panels out of 1.5" tubing and put outside sheet on there to hide the actuators in the bed and route the wiring for them and the taillights inside it.

Rodger
__________________
www.ironworksspeedandkustom.com
Reply With Quote