I've been quite busy the last weeks and haven't had time to work on the project as much as I wanted too :-(
Some of the chassimounts were rusted and the steel was very thin around the holes. I decided to cut out the old steel and weld in new fresh material.
Parts from NPD arrived a two weeks ago with new hood, inner/outer fenders, rear wheelhousings and trunk lid. I have new quarterpanels and doors ready :-) Hopefully I will get some work done on the body within the next weeks. I must say I'm very curious if the sheetmetal fits OK... Time will show!
The Moser Ford 9" axle comes in bare-steel finish, so I have put on some epoxy on it. I've decided to paint the chassi and rearaxle AFTER we are finished with the bodywork.
