I am building up a twin turbo ls2 engine that will put out close to 1000hp and need a rear end that will mate to my DSE 4-link, hold the power, and allow me to run a 6" backspaced wheel in my Mini Tubbed 69 Camaro. Is that what everyone is running for backspacing on their Mini Tubbed first gen's?
What width do i need i narrowed to?
I have been looking at Currie aluminum housings
http://www.currieenterprises.com/ces...E.aspx?id=1567.
Charlie if you are around, I also was wondering what rear end is the Mule using, is it still the Currie Aluminum housing with 3" tubes? What kind of axels? What kind of diff? still a trutrac?
I think i am pretty hell bent on going with a 9" solution. What else am i going to need... i just want to get my 4-link in their and have the car rolling again.
Thanks,
Trev