I have Tyler at ATS making me a crossmember. As soon as he is done I can order my drive shaft and cut my shifter hole.
Headers are out at the coater and should be done tomorrow. Went with the same coating as before just due to the heat disipation. I liked the black when I had it mocked up but want to cut down on heat as much as possible. Once the headers are in..I can start stacking in my Z bar, column, master cylinder..etc.
Dual fan setup should be on it's way.
Vintage air was ordered from Frank last week. Hope to see it no later than the beginning of next week.
Should have front brakes showing up anyday now as well.
__________________
Todd
|