Quote:
Originally Posted by DOOM
Hi Ron
You no for sure the rear was square? Is the deck lid flush with both quarters? If it is then the tail pan has to be out of square. Some of these aftermarket deck lids are twisted and you have to do a little twisting to get them to set right, but if the lid is flush you may have bigger problems.
Mario
|
Sorry Ron
I can see the picture better now my monitor was craping out I have a new one now. What I see looks like you may have a rail up or down. From the picture it looks like the problem may be on the left side (driver) to high. Is that gap on the left side tight ,and wider on the right? Did you put rails in the car? I would see if you can get access to a frame bench to make sure these rails are both at the same hight to the ground. Something has do be out of square . If you live in the Chicago area I can measure all your Datum hights on my bench. This will tell you right away.You can also do this by leveling the car and measuring the rails to the ground but without the rear Datum hight you would be guessing witch rail is up or down..Someone else jump in if you think im way off base here..
Mario