[bentfab]

Well the frame needs to be finished welded where it was boxed. The bottom side of the c-notch needs to be plated. I put the sheetmetal back on the truck so I could see how she sat. Once I did that and was happy with the look I was going to blast it apart which is'nt much flip the frame over and finish weldding the chassis. It needs a trans tunnel made because the tranny was raised when I did the chassis work to keep enerything above the rails. To make it run it needs brake and fuel lines wiring and a few odds and ends. I drove the truck for four years bone stock with drum brakes and a 3 on the tree. It all depends on how you want to finish it too? My dream has alot of simple sheetmetal mods and a couple other trick ideas but I just don't have the time for it to be a personal project. I would like to finish my dream for some one but it would'nt be your average truck when done and needs an open minded person and wallet. Let me know what else you need? Here's a interior shot sorry it ain't the best. If you want I can take more pics?
Thanks