[SN65]

Hi All,

There has been a lot of discussion in regard to the oil cooler installation as far as location goes. Most are concerned with damage and others concerned with air flow. We have reviewed the situation over and over again, but I feel that we have the situation under control. I will be posting photos of the finished installation once complete and then we can all critique it.

Wayne is moving on to the front fenders. He is positioning the flares and working out the design of the leading and trailing edges. Wayne and Dave came into my office yesterday and asked about the lower front valances that were available for the Eleanor kit. They were wondering how that lower valance would look on this car. They said that their jobs would be a whole hell of a lot easier if they could use the molded ends that blended into the front edge of the front fenders.

Well... To make a long story short, we decided not to use the Eleanor front end and to stick with our original plan. Wayne will fab the leading and trailing edges of the flares. We will use the factory front valance (modified with vents for the heat exchanger). Also, to answer a few other questions, we are going to use the factory chrome bumpers front and back. Some argue that a car of this type should have some type of spoiler or a Shelby front valance. I can see their points, but I just can't envision a spoiler that will do the car justice. Also, while I like Shelby clones, I just could not bear to put a Shelby front valance on this car. I know, I know. Using the Shelby "R" style front valance would save me tons of work. No bumper brackets to fab, etc, etc. And we would have plenty of air flow for the radiator and heat exchanger. BUT, I am going to resist the knee jerk reaction to take the easy way out. I think this car should stand on it's own merit. I could not stand it if people walked away from the car thinking It was some altered Shelby clone.

Anyway... It is coming up on 8AM and I have to get to work.

Catch ya'll l8r