Hi All,
Wayne worked late last night on the drivers side fender flare. Before I left for the night (undedicated part timer that I am :-) ) I helped Wayne set the suspension to get the correct attitude. I also established where I wanted him to position the top of the wheel opening. I had already gone through this exercise once before (when the car was on the frame rack on blocks) so all of the "rough" layout lines were pretty well completed at that time.
In the photos below you can see how we positioned the flare, marked up the panel, segmented it and screwed the flare to the fender with sheet metal screws. The positioning of the flare is quite difficult on the Mustang front fender. The problem area is where the fender intersects the bodyline just above the wheel. The flare has to be trimmed back so that the outside edge of the flare ends up exactly where you want it (in relation to the outside edge of the tire).
All Wayne has to do now is form the metal at the leading and trailing ends of the flare. Then we can bond the flare to the fender, finish off the inside surfaces, undercoat the fender, add a layer of fiberglass to the outside edge of the flare, fill and sand and fill and sand and fill and sand....
Catch ya'll l8r