If you e mail me some pics, I can host them for you. You just have to tell me which ones you want me to post for the world to see. Took me a while to figure out how to do that as well and I obviously still haven't mastered it.
They show up too big in the forum.
Got 1 and 2 pistons installed today in preassembly, also set up the degree wheel...The most excitng thing for me today was putting the wire-locks in to retain the piston pin. I've never done that before. The JE's are sweet. I should have excellent quench
Hopefully, I will get to degree the cam tomorrow.
Things are going well so far in pre assembly. I am nervous about cleaning the block when that time comes, I hate using water on cast iron due to the flash rusting...it has already been vatted ( is that a word? )
But you definitely gotta clean again for final assembly.
Ordered some High Temp Paint for the heads. That's about it.
More to come.
Rick
