Here are the best measurements I could get with a smart level and a dail type level.
Rearend \ .7 degrees pinion pointing downward
drive shaft\.4 degrees front of driveshaft pointing downward
tranny /3 degrees rear of tranny pointing downward
So front of rearend is pointing down, front of drive shaft is pointing down, and the rear of the tranny is pointing down.
I think I need to raise the front of the rear end to match the angle of the tranny and try and create parallel lines. So the rear would be 3 degrees raised in the front/pinion.
I'm I going in the right direction?
