Well, the car is in the paint booth as we speak. It's been boarded for the fourth time and is getting it's final wet sand before paint. With any luck Chris will being laying down paint before the end of the week. I'll try to shoot some pictures today.
In the mean time though I guess I should post something before the thread gets completely sidetracked.
Since the splitter pics most of the progress has been subtle and is not really photogenic. We have got most of the engine wired and are waiting for four sensors before we can call it done. Plug wires are built and in place, and the AC lines are out being crimped as we speak (type... whatever). The exhaust is at the coater and the driveshaft is on it's way.
At the back of the car, we have the Optima battery in place as well as the Safecraft fire bottle:
At the front we are looking at some bumpstop alternatives (some are more mundane than others while some are bordering on exotic). No decisions there yet (packaging is tight) but we did a bit of work on the steering arm - baer tracker mounting. One of the difficulties with wider front wheels on the stock subframe (and maybe aftermarket ones as well?) is that when using something like the Baer Tracker tie rod end and bump steer spacers is that the tapered stud is quite long and can interfere with the inner/outer lip of the wheel on the inboard side. Our HREs have nearly a 6" backspacing and interference was definately an issue. The solution is a minor modification to the steering arm and the use of a 5/8" bolt rather than the tapered stud:
Three things to note: (1) there are no any spacers for bump steer in place yet as the car hasn't been aligned at this point (2) a safety washer below the heim is a must and (3) ultimately the castle nut on the top will have a cotter pin in place.
Plenty of clearance now:
