Looking for opinons or suggestions
The few std transmission throttle linkages I have been able to find are way out of my price range. I had an idea to just trim down the pot metal piece getting rid of the electrical part and refinishing to look like it was never altered. After disecting it I just could not figure out a way to trim it down and still keep its structual integrity and the needed stops that are built in to the piece.
I then had the idea to just reverse engineer the piece and just make it from scratch. I whipped it up out of wood to get an idea of how it will look. What do you guys think? Leave it as is, change it a little or start over? The is the side the upper part of the linkage will be attached to and pivot on.
