Bigtyme1 Hope this helps
Open up the doors and tape all the back sides of the doors and hinge area right to the edge of the door with 2in tape, a pain it the ass but you can tape it good. Then tape up the back of the fender jam with the door open again tape close to the edge
Stuff some paper in the hinge area to help stop any overspray.
Take some 2in tape and tape inside the edge of the door so the tape is hanging over the edge of the door so whe you shut it the door the tape will be blocking the door to fender gap to stop the over spary.
You can open the doors during the paint job and paint the jams at the same time but it's hard to get the back side of the doors and fender jams with out them looking dry.
That's going to be the tuff area without shooting it apart
|