I finally have soem installed pics of the new Chassisworks G-Link for you guys to take a gander at. They`re not great pics and these are pre production parts so the final welding and surface finishe aren`t done but it gives you a good idea of where they`ve made changes and improvements. Check out how roomy it is now, exhaust should be a piece of cake. TrueCenter greasable delrin pivots at all 8 points. Note all the adj. holes to tune anti squat, IC location and roll steer. The LCA mounts even incorperate integral trailer tie down loops. I think that`s a really neat touch. They saved additional weight by eliminating a lot of the old tubular upper structure. The new upper mounting structure directly reinforces the unibody rails.The adj. rate swaybar is frame mounted,making it sprung weight and it`s geometry allows it to generate high rates with a small OD and less mass. It`s all very clean engineering and extremely lightweight. Note that there is still NO cutting involved at all. We`ll have better pics in a week or so. The G-Link will also be shipping by then so the pre-order pricing will be over. There`s still a little time to save a few hundred bucks. Mark SC&C
