[JohnC]

Hey Guys,

I know this has been dicussed before, but I'm curious as to what you guys are using...

I want to make my Cuda project as track worthy as possible, but still be able to keep my back seat as useable for people to sit in as possible.

My car has all the XV chassis stiffening stuff so I'm not too worried about rigidity as I am safety.

I wanted to run a 5pt Simpson camlock, but where should attach the shoulder harness mounts??? to the floor? to the backseat belts? or to a removeable cross bar on a 4pt roll cage?

Opinions and suggestions welcome. What have you guys done? And what should I do based on your experiences?

This is a very performance-oriented cuda (high hp, big brakes, lightweight wheels, race suspension) that I want to be as race-ready as possible WITHOUT loosing my useable back seat.

My goal is to do some SCCA solo, Run throught the Hills, Ultimate Street car challenge (if I'm lucky enough to be invited, etc.)...
... but still drive on the street too...

Thanks!!