[jonfarrugia]

I've come to the conclusion that my steering /motor setup will require designing a custom centerlink. I'd like to get some suggestions on how to build it as well as what rod ends to use. All the stock components connect to the center link with a tapperd tie rod. I would assume both the pitman arm and the idler arm will need to be drilled out using a 5/8" striaght drill bit. Between the idler arm/pitman arm and the centerlink there will need to be some kind of spereical joint. The tie rods would connect to the centerlink using rod ends. I'm sure there are many ways to do this but I'd like to get some suggestions on the joints before I start designing one up.