I really needed to get the plasma cutter back to the guy I borrowed it from (our technical rep from Intel loaned his to me - Thanks Anthony!) so Vince and Allen came by on a Sunday to help me get everything that needed cutting...cut.
Thanks for the help guys!!!
Here is the drivers side tub being "test fit". In this photo I have yet to weld in the fill plate so the gap is a bit wide and the tub is still sitting a little crooked because I've yet to fully grind flush the flange:
Welding in the fwd fill plate on the drivers side:
....and the aft plate on the drivers side clamped in place and about 1/2 tacked in:
I've made a bit of progress since these photos were taken. I'll snap a few more tonight. Progress has been a bit slow of late. Work has been busy (beats the alternative) and my wife and I have had a lot going on as well. I hope to be able to wrap the tubs up within the next couple of weeks and then move on to cleaning all the undercoating off the bottom of the car in preparation for starting on the 3-link install. Though I may re-hang the front sheetmetal first. Not sure...