oooooooooops
Yep, sorry- my bad..brown = 12v to the running lamps. When you say you got a complete circuit, are you saying that you're seeing the light come on in your test light?
An easy way to test this is to get a 50 ohm resistor (1w) & jumper the Tan wire-through the resistor-the other end of the resistor to ground. If your wires are good up to that point, you should see about a half tank on your gauge (with the key on, of course).
My apologies for the confusion.
Last edited by ohcbird; 02-20-2009 at 12:46 AM.
|