If all the sub contractors get there parts done we will be shipping the ones that have already sold later this week or next week. we had to make some minor changes for the X body cars.
yes you can buy it complete with a 12 bolt or 9" ready to install the suspension kit is 1999.00 if you want the housing with the brackets factory welded on +710.00 and then you can make it a full factory assembled rear 9" comes with a strange S case aluminum pinion support 1350 yoke 31 spline axles and an auburn posi any gear ratio and any width +2795.00 12 bolt is +2900.00 this is with the brackets welded on.
we have made some design changes to accomidate more modles,
as for installation it should take a first timer about 2 days including welding the brackets, there is probably 30 to 45 mins of welding that is after you have done all the measuring for the rear end brackets, if you were to order the complete rear there would be less that 10 mins of welding the shock mount X member to the frame rails. you can fit a 345 x 20 on a 12" rim with a mini tub and there is room for more.
is a torque arm better than a 4 link??? that is like asking if Ford is better than Dodge?? they both work very well. the install of our torque arm is 90% bolt in it has adjustment for instant center, roll center, ride height, pinion angle, wheel base adjustment, and thrust angle.
the test car is wicked so far, we have more test time scheduled this spring and as soon a Frank gets his and all the others we will have lots of reports.
__________________
Last edited by Blake Foster; 02-22-2009 at 06:31 PM.
|