Quote:
|
Originally Posted by XcYZ
Tom, did you design these to work with an X-pipe of your design?
|
Unfortunately...... no. It would be real hard to fit a 3.5"
true X-pipe under the chassis. The ride heights that we deal with would make it difficult.... but a drag car wouldnt have a problem. You could with our typical ride heights....... pull it off if you went with 3.0".
Another note..... you do not necessarily have to run 3.5" for the entire system. The collector however, has to be 3.5" but aft of that can be a size smaller. The recommended sizing is 3.5" to the front of the muffler and then 3.0" aft of that.