[Beach Cruiser]

More updates.... I swear this build is going to be longer than Marty's Truck! After a long cold wet winter, I've finally gotten back on my project. I trailered the car to my local shop to check sqaureness and Alignment shortly after the first post. It came in 1/16 of being perfectly square, so I'm happy with how the suspension is turning out. Alignment specs are right where I wanted them, from +1 to -5 camber and Minimal Bump Steer. I pulled the motor and trans back out and am now doing the brake plumbing and smoothing the firewall. All the rear brake lines are done as well as the master cylinder, prop valve and the new Hydraulic Clutch assembly. I cut the old beat up firewall out and I'm going to make a new smoother piece. I'm also going to relief the section behind the motor about 1.5" for additional clearance. (the motor is set back about an 1 from stock) I'm not happy at all with the motor mounts, so I'm going to cut them out and make a new set with 1 3/4 DOM tubing, extending up to the shock mounts for additional support on the suspension.

The last pic shows why I havn't been working on the car as much as I should, I've developed this nasty racing habit that I can't kick...

Sorry to disappoint you guys with the pictures but the Bikini babe is gone, My wife said I couldn't keep her when she moved back in the house this fall.