[Musclerodz]

There was a thread over at PT.com about this chassis and I wasn't to impressed with it considering they build race car chassis. Here is just a short list IMO:

1. FVSA way to short. camber gain in bump has to be crazy
2. Shock hoops have no lateral support and with the coil over not mounted
and will flex in a turn. The tower bar does very little except to transfer
some load to the welds on the other hoop. A Monte Carlo bar would be
better.
3. Billet aluminum solid motor mounts. I hope they are 6061 T6 or forget it.
4. Rod ends in the upper rear link picture look to be radial only so they will
bind almost imediatley
5. Picture may be decieiving but it appears there is very little clearance
between the sway bar arm and the R&P arm. Could be ugly in the right
situation.
6. I also wonder about torsional rigidity. The outer rails look ok, but don't
know about the rest.

Mike