[abadsvt]

I got a little more progress done. I decided to work on the bed until its completly done minus paint and body. So i have been focusing all of my energy on that. I built new inner bedsides skins and changed the front bed panel to match the sides. I also took some 1 1/4" wood and jointed it, plained it down to the correct thickness I needed for the wood floor. I took stainless flat bars and welded studs on them so all the bolts will be under the bed so you don't see any bolts or anything from the top. The stainless will be polished at a later date. I recessed it down so its all flush. There not bolted in yet so in some of the pics they might look tighten down and the wood is just sitting there so the aren't fully aligned yet. My table saw broke some sort of pin so i couldn't finish the wood and i also ran out of the stainless flat bar. Thats why some are missing. Anyways heres some pics.












Josh