I have a few questions Scott. It appears that you're using a Fox body mustang rack. Did you perform any modifications to it?
The rest appears to be C6?
Were there any specific requirements you were trying to hit when designing the geometry?
I'm in the process of planning my front sub utilizing C5 components. What is your flange to flange width with that rack?
Are you happy with the way your steering arms turned out? I've been trying to think of a cost effective method to create some arms for my sub, but thought the accuracy required for them would be higher than what's achievable with bent steel. If you're happy with your approach I might have to look into doing something similar.
|