Then we started to lay out the design for the floor and how we would incorporate the suspension design for the pick up points into this. So we decided to build the main framerail structure inside the rocker to act as the frame rails that would go inside the Rocker and build low profile crossmembers that would be even with the bottom of the rocker. So nothing would hang below the rocker. Plus the design of these allows our floor to be 2" below the stock height of the original floor. Plus it will give us tons of lateral support and resist chassis flex.
Paper mock up from the blue print printer.
Crossmember jig fixture
Floor mocked up on table
Mocking up the Floor in the car
We should begin to start bending tubes and getting the lower suspension pick up points located in the next few weeks.
Enjoy