[TreySmith]

I started on the floor today. I got one rear seat section cut out, it is the worst part of the floor I can do. The passenger rear I need a pan for so I didn't do that first. The rest of the floor should be a piece of cake since the rust isn't that bad. I cut out the rust with a cutoff wheel and then used the cut piece to make a rough outline onto some quarter panel metal off a 72 cuda'. Then I set the cut piece under the car and rested it on the muffler, then used some black paint to get a spot on outline. The piece needs a little bit more trimming but it pretty much fits perfect. I was going to weld it earlier but someone else is using it, so I might do it later today.

Also some pics of the bodywork below. The right side still needs to be sanded down. Thanks Bob for the extra trunk lid.