I rewelded my subframe with a mig and it worked out fine. Its messy with flux core so if you have something that you want to visually see then I would suggest a mig with shielding gas conversion.
Shielding gas will cause cooler welds and possibly less penetration depending on what welder you use so I went for the flux core but I needed to weld in some inconspicuous areas. Im using a 220 volt mig welder now with a gas tip but I didnt use gas on the frame but I will for some tubbing and some other sheet metal work.
Last edited by shaggy56; 08-06-2009 at 08:37 AM.
|