We are plugging along. Just about have the bottom of the car done and ready for bedliner. Had some issues with both frame rails after blasting. The northern salt had taken its toll on them in a few places and thinned them out a little. With no budget left, I decided to just take a little time and fabricate new rails. New rails are 10 gauge material formed identical to the stockers, each rail is 6 separate pieces that were pieced together to form a rail that look almost identical to factory. You can also see in the pics a lot of spot welds on the rockers and so fourth shaving the not needed trim holes and misc holes that were drilled in this thing. Apparently it had been through a LOT of exhaust systems in its life time , and no body could figure how to use an existing hole. 14 holes in drivers side and 17 holes in passenger side, where the stock hangers were. You can also see were both front half pans were removed and are being replaced with Goodmark halfs...
We'll be finishing the floor and starting on suspension this week.
