Quote:
Originally Posted by Apogee
The front bearing packs are consumable items, so if you can find a press-in M12x1.5 stud with a suitable knurl diameter to fit in place of the existing 1/2-20 studs in the rear axles, or resize them larger if necessary, that would seem to be the best long term solution in my mind.
Tobin
KORE3
|
Yes. Good point.
I found some Dorman 1/2" studs with a .530" gnurled area.It took just a little enlarging of the holes in the front hubs to get them to press in. I used a 33/64 drill to open the hole, and just pulled them in with a lug nut from the front. Worked like a charm.