Quote:
Originally Posted by camaro2nv
Hmm should I just use the one Morrison sent? Its thicker. Nothing is set as of yet. This is just mock up.
|
Are they specifically for a wilwood setup? I tweaked one of my wilwood retainers a hair. I ended up with a set of currie retainers that go all the way around the bearing. On mine you could see the bearing move away from the retaining clip with your bare eyes! I had over .020 on both sides. I was able to get it down to .005 and .006 with the currie plates. Do yourself a favor an measure it now while it's mocked up. Wilwood was working on a new design when I talked to them 2 months ago. The new design was shimmable.